There is not the know-how even if I say about "the painting".
I introduce the painting that I tested so far and consider it as contents only of a weak point.
I think whether it should have seemed that tried one will "be careful because I become it in this way if I did it this way" and describe it.
Oh, is it almost a sob story?・・・^_^;

It is FeROYAL of G Smith S. I paint most ABS models with this paint. It is paint with iron powder. It is the paint which it can dye be gun blue after the painting.

At first I polish the painting product and make it the smooth surface. I make that I damage the surface lightly, and paint sticks better. I drop an oil with detergent neatly. And I spray paint. Fog of paint seems to be comparatively large, and this paint gains a lot of paint at a time. Please be careful. 　(Merely I am clumsy?!!)
	There is notation with drying to instructions after the painting for 72 hours. However, I think of one month so that the one that I dried may stiffen. The surface after having painted it is in a condition to be near to the satin finish.
	There is it to instructions with abrasion by exclusive nylon pat after drying.However, It become it in this way if I study hard to pat it lightly with steel wool . But paint comes off when I polish it too much and it becomes often that I win steel wool well and polish too much edge parts. I am to watch out.
	I dye it into blue with the back blue liquid which polished this. (It may be incomprehensible with this photograph.) Because iron powder is included in paint, it is dyed be steel blue. I pull oil after having dyed it. Because rust occurs on the surface, for paint with iron powder, it is necessary to attach oil. I am to watch out.

Mistake

	Because a carved seal was thin, paint entered, and a carved seal has disappeared. But a color is beautiful?
	The painting has come off in abrasion overdoing.(T_T) In addition it is the photograph which a focus does not fit !. In addition, I will redo taking it.